* Click here to visit our new Roland website.

DT-1

V-Drums Tutor

DT-1 Compatibility with V-Drums Sound Module

2015/10/27

The DT-1 is compatible with the following V-Drums Sound Module.
There are some remarks for each connection cable, please make sure of the setup with the "*" remarks below:



*1: Required to connect the MIDI Interface/Audio Cable with the V-Drums

  • Please setup a MIDI Interface and an Audio Cable to connect with the V-Drums.
  • For this connection, please use the proper cables that are suitable in the size and shape for the connection jack.


*2: Required to connect to the USB Computer Port of the V-Drums

  • Please set up a USB cable to connect your computer with the V-Drums. (For TD-30, when the system program is Ver.1.10 or later. *)
  • For this connection, please use the proper cable that are suitable in the size and shape for the connection jack. * If your TD-30 is less than Ver.1.10, an Audio Cable is also required with a USB cable.
    * If you use the TD-1, you also need an Audio Cable.
  • When you're using with the TD-25, download the TD-25 driver and install it on the computer you're using. At this time, refer to the TD-25 Parameter Guide and set the USB driver mode to "VENDOR."
    * If you're not using the TD-25 driver, an audio cable is also required in addition to the USB cable. At this time, set the USB driver mode to "GENERIC."


*3: Caution when you use the TD-25/TD-30 with DT-1 for Mac

In this case, you need to update the "DT-1 for Mac" to Ver.1.01 or later.



To the top of page